Go Hilti

October was the expected launch date. I just sent out some feelers to see if there was a delay in getting it to distribution. Unfortunately, delays have been common with most brands. We were working on an angle grinder article a few months ago and it took almost 6 months to get here! The folks on the brand side that we talk to are frustrated, too. Everyone wants to set reasonable expectations, but the supply chain still has its issues. The good news is that it looks like our ports are finally clearing the backlog, so hopefully, we’ll see fewer delays on what’s coming in via import.

I know that’s a longer reply than you asked for, but I’m hoping the additional context helps! I’ll let you know as soon as I hear back from Ryobi about an updated arrival date.

🙋
Q: Your solar panels local made or imported? If imported, are they China Made?

LFP 🔋 are ideal for Statics Storages. Like Fossil ⛽ are subjected to “Supply and Demands” ─ cost directly variable of Demands.
Electrified Tools and Electricity outside Solar Energy, at local generated from what sources? As USA rated at 71%+ on Fossil Fuels (Coals, Oil & Gas); when all demands of Electric Powers (Vehicles and Powered Tools) can current Grids handle the Loads at Peaks hrs? Over heard that even California could not handle the loads advisory of limit uses of Charging’s BEV (only 2% Vehicles in Golden States are BEV’s.

Let’s assumed that there were 50% BEV’s ─ how long would we be ready for that “Subjunctive Condition”?

Happy Holidays to all.

That’s a good point. Makita’s was the lightest for a while and then Metabo HPT came two pounds lighter with its 36V rear-handle.