Comments on: Skil 14-Amp Router Review RT1322-00

By: John

John — Fri, 09 Sep 2022 16:15:20 +0000

what insert bearing kits does the 1322 accept?

By: Kenny Koehler

Kenny Koehler — Tue, 30 Nov 2021 13:11:21 +0000

In reply to Bruce.

Hey Bruce, thanks for your question! On this unit we reviewed, there’s a 4mm hex key access underneath the macro adjustment screw that allows you to raise or lower the bit height when it’s attached to a Skil router table. Just like when you make macro or micro adjustments using the thumbwheels, you need to release the locking clamp to free it up for adjustments.

Hope this helps!

By: Bruce

Bruce — Tue, 30 Nov 2021 04:01:10 +0000

Hello Chris. With this router is there an adjustment key for raising and lowering the bit in a table to change the bit? I have this router, and didn’t come with adjustment key. If so, what size key? On my unit there is a stop loaded to hold collet to put wrench on to change the bit. Does this feature stop bit from being raised and lowered also? Thx for your review. Bruce L

By: Kenny Koehler

Kenny Koehler — Fri, 16 Jul 2021 19:40:27 +0000

In reply to Z12345.

We enlarged ours to 1-1/2″ without a problem. It’s about 1-1/4″ to start, so a 1/2″ roundover will fit easily.

By: Z12345

Z12345 — Fri, 16 Jul 2021 19:32:33 +0000

What size roundover bit were you able to push through to enlarge the base plate hole? Is it possible to push a 1/2” roundover into the hole?